SST768 FLOW rate problem HELP ME!

[belencsakl]

Hi,
I have a SST768 with the original T12 tip. Printer Wokr fine. The tip is not clogged.
BUT: the extruded ABS material thickness only 0.4mm !! And the normal on my BST768 about 0.6mm.
SO to less I changed soon the extruder motor but no any change. Flow rate week
I think, i must change the flow rate parameter in the machine CFG. But WHICH PARAMETER CHANGE THE FLOW RATE????
Any Experience???

[belencsakl]

I had problem with the first layer on PEI sheet. I changed the config file:

FirstMainFlowAdj=100,96000,1.6,0; (original was: FirstMainFlowAdj=100,40000,1.75,0; )

in the mvcplr.cfg ( on Dimension) now is better stick on the first layer with PEI sheet without any base support layer.