Close
Login to Your Account
Results 1 to 1 of 1
  1. #1
    Join Date
    Jan 2018
    Location
    Posts
    7
    Downloads
    0
    Uploads
    0

    Weird curling problem when printing a thin item in 100% infil

    The print job is a 4.5mm thick plate (lid actually) that is 155x160mm (See attached stl). It will curl on the front right side of the print when printing infills of 50% or greater. Al though due to time constraints I only tested in 20% (my normal go to infill), 50% and 100% (What my goal infill for this job was)
    • The printer is a maker select 2 that I've had for many years.
    • The bed surface material was replaced a few months ago also but not because of this, just because it was years old.
    • I am using the same filament I've been using for 2 rolls from amazon (SUNLU).
    • I've had no other issues w/ this filament and reviews have been good
    • I print at 210/40C and always have w/o any issues
    • printer config:


    • Maker Select 2
    • I have a duct w/ a cage fan that cools prints. Print cooling fan is running after layer 2
    • 210/40C
    • 1st layer 15mm/sec
    • all other layers 50mm/sec
    • .28mm layer height
    • 210/40C



    print info and tests I've run on same job
    • If I print the job at 50% infill it's better
    • If I print the job at 20% infill it does not curl
    • Tried to reduce printhead temp to 200, no change
    • Bed is level to .001" as confirmed w/ a feeler gauge
    • Bed is clear of any debris



    I don't think it's pertinent here but I have included a copy of the item I was printing.
    Attached Files Attached Files


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEED HELP Anycubic Mega x Skipped Layers on Thin Parts
    By AirCondaTV in forum Beginners (New to 3D Printing)
    Replies: 0
    Last Post: 10-19-2021, 06:04 PM
  2. DISCUSSION How to avoid the thin and difficult to remove raft/support?
    By 3dprintuser in forum Post-Production Tools & Techniques
    Replies: 0
    Last Post: 06-17-2020, 10:20 AM
  3. curling effect
    By moosbach in forum Stratasys
    Replies: 4
    Last Post: 09-16-2016, 03:05 PM
  4. NEED HELP Weird Folgertech i3 behaviour
    By Hardwood in forum Beginners (New to 3D Printing)
    Replies: 0
    Last Post: 10-06-2015, 10:45 AM
  5. NEED HELP Edge-curling and Printing an object with a large base
    By hunterjwizard in forum Beginners (New to 3D Printing)
    Replies: 3
    Last Post: 12-12-2014, 09:27 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •