Results 1 to 5 of 5
-
10-29-2019, 09:29 PM #1
Newcomer
- Join Date
- Oct 2019
- Location
- Posts
- 3
- Downloads
- 0
- Uploads
- 0
1st layer prints great everything else extrudes uneven
Good Afternoon,
1st post here so I apologize if this is an extremely basic question. I have been printing for years on a Robo 3D R1 printer for custom rod handles I make with Carbon Fiber handles. Never had an issue that had me stumped. I just can't seem to figure this one out however. I have attached the image of the print of a 35mm square box for calibration and as you can see the extruder is doing its own thing. I have attempted the following:
- Cleaned the extruder and nozzle
- Cleaned the drive gear
- Adjusted the spring tension on drive gear
- cleaned print bed
- adjusted extrusion temperature up and down
My next step will be to try a new filament but I am not confident that will resolve it. These same settings have worked flawlessly in the past so I am having troubles determining where to go from here. Any input would be greatly appreciated and once again I apologize if this seems like common sense as I have been self taught keeping the R1 operating.
image0.jpg
-
10-29-2019, 09:34 PM #2
Newcomer
- Join Date
- Oct 2019
- Location
- Posts
- 3
- Downloads
- 0
- Uploads
- 0
I forgot to mention that I am printing an ABS 1.75mm. My heat is set to 225 degrees C.
-
10-29-2019, 09:39 PM #3
Newcomer
- Join Date
- Oct 2019
- Location
- Posts
- 3
- Downloads
- 0
- Uploads
- 0
Attached is the results of the ice rods I make using abs 3d prints as the core of the grip
-
10-31-2019, 04:26 PM #4
Newcomer
- Join Date
- Dec 2013
- Location
- Posts
- 1
- Downloads
- 0
- Uploads
- 0
-
11-01-2019, 01:29 PM #5
Newcomer
- Join Date
- Oct 2019
- Location
- Posts
- 6
- Downloads
- 0
- Uploads
- 0
can anyone here help me out with my issues ?
- - - Updated - - -
I've got some serious issues with my printer as well.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEED HELP Consistently Uneven Print
By dfarrar in forum Beginners (New to 3D Printing)Replies: 1Last Post: 11-01-2019, 02:01 PM -
News Great news from Endurance.
By gf_endurance in forum Manufacturer News & AnnouncementsReplies: 0Last Post: 12-16-2017, 04:36 AM -
DISCUSSION Great printing
By Wendy in forum Beginners (New to 3D Printing)Replies: 0Last Post: 07-08-2017, 04:12 AM -
NEED HELP HELP when i press extrude it reverses ; when I press reverse it extrudes
By colincolin30 in forum Beginners (New to 3D Printing)Replies: 3Last Post: 12-10-2014, 08:44 AM -
DISCUSSION Large prints vs small prints involving gluing/fastening pieces together
By EfficiencyPlus in forum Beginners (New to 3D Printing)Replies: 2Last Post: 07-08-2014, 12:39 PM
Bookmarks