PDA

View Full Version : MakerBot 3D Digitizer



SomeSailor
01-03-2014, 09:39 PM
I have one here if anyone needs anything scanned?

Andrew Werby
01-04-2014, 04:48 PM
I'd like to see a sample of its output, on a part that has a good amount of detail. Have you been using it long? How do you like it? What are its limitations, and what are its strengths?

Andrew Werby
ComputerSculpture.com ? Home Page for Discount Hardware & Software (http://www.computersculpture.com)

i04p
02-10-2014, 06:56 PM
How much do these cost? And how do they work? I assume these diy machines.

RickNaylor
02-10-2014, 07:13 PM
Do you have a link to demonstrate how the scan works? Round objects in 3D vs square and flat.

i04p
02-10-2014, 08:03 PM
it would be good to know its accuracy as well.

scrollzilla
02-10-2014, 08:14 PM
How large of an item will it scan? Is this similar to the copier tools on a cnc where it uses a probe?

Nchapman
02-10-2014, 09:39 PM
The typical price is $1400 but are currently on sale for $949. Kinda high priced in my opinion. The current scan size is 8" diameter x 8" high. The accuracy is +- 2mm which isn't bad. You could do just as good if not better using the xbox connect.

LuckyLuc61
02-11-2014, 06:37 PM
Not a 3d scanner for a low price ??? DIY ?

C*H*U*D
02-20-2014, 01:59 PM
Does anyone have a model file created by one of these? We are looking at getting a Makerbot Replicator at work to take some of the load off of our Stratasys, and this caught my eye.