PDA

View Full Version : auto leveling, weird curve XY axis



Xienix
12-06-2014, 06:28 PM
hey folks


We're finally done designing/making most of the 3D printer (here (http://i.imgur.com/R9JVoq4.jpg)) but when I did a test run for the X and Y axis it had a curve in the Z axis...I'm not good at explaining so here's a drawing http://i.imgur.com/67W0KQ1.png
Red is the path the effector is following now, Yellow is the path it should follow, blue is the effector


does someone know what I need to change/adjust in order to get a straight Y and X axis?
We're working with the marlin firmware here by the way

Mjolinor
12-07-2014, 01:42 AM
Assuming it is a Delta printer then you have not entered the dimensions correctly. Maybe length of arm or other stuff. Check your measurements.

Xienix
12-07-2014, 07:36 AM
Assuming it is a Delta printer then you have not entered the dimensions correctly. Maybe length of arm or other stuff. Check your measurements.

it turns out that I forgot to enter the printing radius in some places, it's working now
it's a delta printer http://i.imgur.com/R9JVoq4.jpg